Configure The Ma Output; Configure Ma Output Process Variable - Emerson Micro Motion SGM Series Configuration And Use Manual

Integrate the meter with the control system
Option
mA output
Discrete output
10.2

Configure the mA output

The mA output is used to report the configured process variable. The mA output
parameters control how the process variable is reported.
The SGM mA device has two mA outputs: Channel A and Channel B. Both outputs are fully
configurable.
The SGM DO device has one mA output: Channel A. The output is fully configurable.
The SGM TPS device has one mA output: Channel A. The output is fully configurable.
The SGM Fixed device has one mA output: Channel A. The output is not configurable.
Important
Whenever you change an mA output parameter, verify all other mA output parameters before
returning the meter to service. In some situations, the transmitter automatically loads a set of stored
values, and these values may not be appropriate for your application.
10.2.1

Configure mA Output Process Variable

ProLink III
Field Communicator Configure > Manual Setup > Inputs/Outputs > mA Output 1 > Primary Variable
Overview
Use mA Output Process Variable to select the variable that is reported over the mA output.
Prerequisites
If you are using the HART variables, be aware that changing the configuration of mA
Output Process Variable will change the configuration of the HART Primary Variable (PV)
and/or the HART Secondary Variable (SV).
Procedure
Set mA Output Process Variable as desired.
Default settings are shown in the following table.
96
Description
Channel B will operate as the secondary mA output.
Channel B will operate as a discrete output.
Device Tools > Configuration > I/O > Outputs > mA Output > mA Output 1 > Source
Device Tools > Configuration > I/O > Outputs > mA Output > mA Output 2 > Source
Configure > Manual Setup > Inputs/Outputs > mA Output 2 > Secondary Variable
®
Micro Motion Gas Specific Gravity Meters (SGM)