Table of Contents
Advertisement
76 •
Fieldbus Controller
Fieldbus Controller 750-872/020-000
3.1.7.3 Transmission Mode Configuration
Both the controller and its link partner must be configured for the same
transmission mode to ensure reliable and fast communication using the
Telecontrol controller, which means they must operate either in (default)
autonegotiation mode or full or half duplex mode with 10/100Mbit static
transmission rate.
If the transmission mode must be set to match the link partner, the "Ethernet"
link can be used to access a web page on which the transmission rate and the
bandwidth limit can be adjusted for the Ethernet transmission. These values
should only be modified in exceptional circumstances.
Note
A faulty configuration of the transmission mode may result in a link loss
condition, a poor network performance or a faulty behavior of the
coupler/controller.
Further Information
Please find detailed information on how to configure the transmission mode in
the chapter "Fieldbus Communication"/"ETHERNET"/
"Fieldbus Communication"/"ETHERNET"/
"Network Architecture – Principles and Regulations"/"Transmission Mode".
WAGO-I/O-SYSTEM 750
ETHERNET TCP/IP
Advertisement
Table of Contents
