Table of Contents
Advertisement
Serial Interface Modules with alternative Data Format
750-650, (and the variations /000-002, -004, -006, -009, -010, -011, -012,
750-651, (and the variations /000-002, -003)
750-653, (and the variations /000-002, -007)
Note:
With the freely parametrizable variations /003 000 of the serial interface
modules, the desired operation mode can be set. Dependent on it, the
process image of these modules is then the same, as from the appropriate
variation.
The above Serial Interface Modules with alternative data format have a total
of 4 bytes of user data in both the Input and Output Process Image (3 bytes of
serial data and 1 byte of control/status). The following table illustrates the
Input and Output Process Image, which have a total of 2 words mapped into
each image. Word alignment is applied.
The specialty modules represent 2x2 bytes input and output data and seize 2
Instances in Class (0x67) and 2 Instances in Class (0x68).
Serial Interface Modules with Standard Data Format
750-650/000-001, -014, -015, -016
750-651/000-001
750-653/000-001, -006
The above Serial Interface Modules with Standard Data Format have a total of
6 bytes of user data in both the Input and Output Process Image (5 bytes of
serial data and 1 byte of control/status). The following table illustrates the
Input and Output Process Image, which have a total of 3 words mapped into
each image. Word alignment is applied.
WAGO-I/O-SYSTEM 750
ETHERNET TCP/IP
-013)
Input and Output Process Image
Byte Destination
Offset
High Byte
0
D0
1
D2
Process Data Architecture for EtherNet/IP
Low Byte
C/S
Data byte
D1
I/O Modules
Remark
Control/Status byte
Data bytes
• 243
Advertisement
Table of Contents
