Table of Contents
Advertisement
5. To logon as the administrator, enter the user name admin and the password
Note
If the controller does not display the opening HTML page, make sure your
web browser is setup to bypass the proxy server for local addresses.
6. A list of all protocols supported by the controller is displayed. The BootP
7. You can disable other protocols you do not need in a similar way, or enable
8. To store the protocol selection, click the SUBMIT button and then perform
9. The protocol settings are now stored EEPROM and the controller is ready to
WAGO-I/O-SYSTEM 750
ETHERNET TCP/IP
wago.
protocol is activated by default. To disable the protocol, click on the check
box after BootP to remove the check mark.
protocols you wish to use. It is possible to enable several protocols at the
same time, since each protocol uses a different port.
a hardware reset. To do this, either switch off the power supply of the
controller or press down the operating mode switch.
operate.
Fieldbus Controller
Fieldbus Controller 750-872/020-000
• 75
Advertisement
Table of Contents
