Installation Of The Firewire Driver For The Variocam - InfraTec VarioCAM User Manual

(IEEE 1394) cable, 6-pin, page 18) makes the hardware connection between the PCI-IEEE 1394 interface
of the PC and the VarioCAM
Should the thermographic system VarioCAM
supply, the manufacturer will not accept any liability for the appropriate operation of the
thermographic system.
9.3

Installation of the FireWire Driver for the VarioCAM

For installing the device driver "vc_hires23", the access rights of the user group "Administrators" are
definitely required. After successful installation, the programme IRBIS
with the access rights of the user group "Main users".
®
VarioCAM hr and the PC/notebook are connected with the help of the included FireWire (IEEE1394)
cable. Then the PC/notebook and the thermographic system are to be powered on.
Fig. 147 Device manager – "Imaging device"
Should you already have installed the infrared camera VarioCAM
the file "VC2.inf", the camera will register within the device manager under "IEEE 1394 bus host
controller". In this case, the current driver "vc_hires23.inf" must be allocated by function "Update
Driver..." (see Fig. 149). To call the pop-up menu "Update Driver...", highlight the device driver first and
confirm with a right mouse click.
The driver "vc_hires23" is a digitally signed device driver.
68
User Manual for the Thermographic System VarioCAM
®
hr.
© InfraTec GmbH 2013
9. Hardware and Software Installation for VarioCAM® hr*
®
hr be operated by a PC without any separate power
Fig. 148 Automatic hardware detection
®
hr into your control PC by means of
® high resolution
®
hr
®
online/process can be used
User Manual