ABB DG/S 1.1 Product Manual page 57

®
ABB i-bus EIB / KNX
© 2006 ABB STOTZ-KONTAKT GmbH
Functional description
No. Function
12 Selected Device Burn in
&
30 Lamp
Channel X Selected Device Burn in Lamp [EIS 1; 1-bit switching]: The function "Burn in
Lamps" (see General parameter window) for protecting the ballasts and the lamp during the
initial operation is activated or deactivated via this object. After receipt of a telegram (value
"1"), the lamps of the DALI device selected beforehand via the "Select Device" object (no. 7)
can only be operated at 0% (off) or 100% brightness for the parameterised period. The burn-
in period can be adjusted in the "General" parameter window. After this time has elapsed the
device can be dimmed as usual and the programmed lightscene can be recalled. If a
telegram (value "1") is received during the burn-in time, the period restarts from the
beginning. A telegram with the value "0" deactivates the function and enables normal
operation. The burn-in time is only counted if DALI equipment is connected to the channel
and supplied with power.
The burn-in function is deactivated after a download or operating voltage failure on the DG/S
1.1.
Telegram value "1": Activate function
"0": Deactivate function
Note: If for example, the burn-in time should be activated after initial installation or after a
complete exchange of all lamps, the general communication object no. 247 "Burn in Lamps"
is more suited to the purpose.
13 Selected Device Read
&
31 Position
Channel x Selected Device Read Position [EIS 1; 1-bit switching]: The current switching
state of the DALI device selected beforehand with the "Select Device" object (no. 7) is
queried via this object (e.g. for visualisation purposes), depending on the parameter setting
(Status parameter window).
Telegram value "1": On
"0": Off
14 Selected Device Read
&
32 Brightn.
Channel X Selected Device Read Brightn. [EIS 6; 1-byte value]: The current brightness
value of the DALI device selected beforehand with the "Select Device" object (no. 7) is read
via this object (e.g. for visualisation purposes), depending on the parameter setting (Status
parameter window).
Note: In the DALI command code, the value 255 means no change in brightness. The
maximum brightness level (100%) in DALI is 254. A 100 % brightness value of 255 via
EIB / KNX is automatically transformed to 254 in the DALI-Gateway. This fact is also taken
into consideration when reading out a brightness value. A maximum DALI value of 254 is
transformed on the EIB / KNX to 255.
15 Selected Device Lamp
&
33 Failure
Channel X Selected Device Lamp Failure [EIS 1; 1-bit switching]: A lamp fault (e.g.
defect) of the DALI device selected beforehand with the "Select Device" object (no. 7) is
transmitted or read via this object (e.g. for maintenance purposes), depending on the
parameter setting (Status parameter window).
Telegram value "1": Fault of one or more lamps on the channel
"0": No fault
Object name Data type
Channel A or 1 bit (EIS 1)
Channel B DPT 1.010
Channel A or 1 bit (EIS 1)
Channel B DPT 1.001
Channel A or 8 bit (EIS 6)
Channel B DPT 5.001
Channel A or 1 bit (EIS 1)
Channel B DPT 1.005
Flags
C, R, W
C, R, T
C, R, T
C, R, T
53