ABB DG/S 1.1 Product Manual page 15

®
ABB i-bus EIB / KNX
Isolation category
EIB / KNX safety extra-low voltage
DALI voltage
Temperature range
Design
Installation
Mounting position
Weight
Housing, colour
Approvals
CE mark
Table 2 b DALI-Gateway DG/S 1.1, Technical data
Note: The DALI-Gateway conforms to the SELV properties in accordance with DIN EN 410. DALI does not require
SELV properties, and it is possible to route the DALI control lines together with the mains voltage on a multi-core
cable.
Connection of 230 V mains voltage to one of the DALI outputs leads to the destruction of the DALI end stage and
the output.
User programs
Device designation Application program
DG/S 1.1 Dim Lightscenes Dynamic 1f/1
Table 3 Application programs for DG/S 1.1
Note: The programming requires EIB Software Tool ETS2 V1.3 or higher. If ETS3 is used, a ".VD3" type file must be
imported.
The user program is located in ETS2 / ETS3 under ABB/Beleuchtung/ DALI/ Dim Lightscenes Dynamic 1f/1.
© 2006 ABB STOTZ-KONTAKT GmbH
Device technology
- Overvoltage category
- Pollution degree
- SELV 24 V DC
- typical 16 V DC (9.5...22.5 V DC)
- Operation
- Storage
- Transport
- Modular installation device (MDRC)
- Dimensions
- Module width
- Mounting depth
- On 35 mm mounting rail
- As required
- 0.190 kg
- Plastic housing, grey
- EIB / KNX to EN 50 090-1, -2
- in accordance with the EMC guideline and low
voltage guideline
Max. number of
communication objects
251
III to DIN EN 60 664-1
2 to DIN EN 60 664-1
to DIN IEC 60929 / 62386
-5° C ... + 45° C
-25°C...+ 55°C
-25°C...+ 70°C
Modular installation device, proM
90 x 72 x 64,5 mm (H x W x D)
4 modules at 18 mm
68 mm
to DIN EN 60 715
Certification
Max. number of group Max. number of
addresses associations
254 254
11