ABB DG/S 1.1 Product Manual page 33

®
ABB i-bus EIB / KNX
© 2006 ABB STOTZ-KONTAKT GmbH
Functional description
Behaviour with retriggering: If renewed triggering occurs during phase
(telegram with value "1"), the dynamic sequence continues unchanged. With
an ON telegram in phase
ON telegram "1" in phase
rerun.
An OFF telegram ("Channel X ON/OFF = "0") in phase
If an OFF telegram in phase
continued unchanged or is retained until the switch OFF value.
The dynamic operation ends after a download. The brightness level which is
used at the end of the dynamic operation is set ("standby" state).
Fig. 9: Parameter window "Device – dynamic operating mode"
Device Number
Option: A01
A02
...
A64
With this parameter, it is possible to define which DALI devices (1 to 64)
are to be parameterised in channel A of the 1-fold DALI-Gateway.
The device numbers (1...A64) correspond to the allocation of the
EIB / KNX names "Device A01" to "Device A64".
Note for the specialists: The DALI addresses which the
EIB / KNX user does not require are reduced by one, i.e. the
DALI device on the EIB / KNX with number 01 has the DALI
address 00. Device 64 has the DALI address 63. The offset
has been taken into consideration in complete application
programs with all parameters and objects as well as in the
DGS11 Software Tool. The user only needs to use device
numbers from 1 to 64.
, runtime 8 (stop phase)
or has the effect that phases
or is received, the dynamic operation is
recommences. The
and are
or has no effect.
29