Table of Contents
Advertisement
R
Connection Details
Analog Audio Connections
Wire the audio input and output connectors as shown in figure 10. Use the supplied tie
wrap to strap the audio cable to the extended tail of the connector.
NOTE: These instructions do not apply to the amplified audio output connector on the
Audio Inputs and Outputs 1 – 4 and Aux
Sleeves
Sleeves
Mic/Line Inputs 1 and 2
Ring
Sleeve
Figure 10.
LAN port — Single Ethernet connector. The IN1806 and the IN1808 base model
5
each have a LAN connector to the left of the Remote RS-232 connector (see
figures 3 and
4,
, on pages 12 and 13) instead of the LAN and AV LAN ports on
K
the IPCP models (see
eBUS port — 5-pole captive screw connector supporting up to eight eBUS
6
endpoints, with a maximum power output of 9 watts
Relay ports — Four relays on two 3-pole captive screw connectors containing
7
individual contacts for each relay and a shared Common (
supports 24 VDC of power and up to 1 amp of current.
IR/Serial ports — Two unidirectional RS-232 or IR ports (configurable), which
8
share a single 5-pole captive screw connector
Reset button and LED — Pressing this recessed button causes various IPCP
9
settings to be reset to the factory defaults. The green power LED blinks depending
on the selected reset mode.
HDMI input connectors (Inputs 2 through 6) — Connect HDMI video sources to
these female HDMI connectors.
TIP:
Use Extron HDMI LockIt Lacing Brackets to secure HDMI cables to the device
(see
HDMI Connections
IN1808 IPCP SA and MA models.
Tip
Ring
Tip
Ring
Balanced Audio Input
Tip
Ring
Tip
Ring
Balanced Audio Output
Tip
Balanced Audio Input
Analog Audio Wiring
IN1806 and IN1808 Series Scaling Presentation Switchers • Installation
figures 5 and
6,
, on page 13).
Q
on page 20).
Tip
Sleeve
Tip
Sleeve
Unbalanced Audio Input
No Ground Here
Tip
Sleeves
Tip
No Ground Here
Unbalanced Audio Output
Tip
Sleeve
Unbalanced Audio Input
Do not tin the wires!
) connector. Each relay
C
19
Advertisement
Table of Contents
