Table of Contents
Advertisement
Over TP IR pass-through connector — To transmit or receive infrared data to and
G
from a sink connected to a DTP or DTP2 receiver, XTP matrix, or HDBaseT display,
connect a control device to the 3-pole Over TP IR captive screw port (see
on page 12 and
figures 4 through 6
connector.
IN1806 or IN1808
Tx, Rx, and G Pins
Figure 7.
Wiring the Over TP IR Connector
NOTE: RS-232 communication can also be sent to the far end of the twisted
pair connection, but it must be done through RS-232 insertion via Ethernet. A
control signal applied to an IN1806 or IN1808 Series LAN or AV LAN port can be
routed to the RS-232 port of any connected twisted pair device (see
RS-232 Insertion
Analog audio line input connectors 3 and 4 — Connect line level analog audio
H
sources to audio input connectors 3 and 4 on the 5-pole captive screw connector
for balanced or unbalanced stereo audio (see
Connectors are included with the unit, but the audio cable is not (see
page 19 for wiring).
Analog audio Mic/Line input connectors 1 and 2 — Connect balanced or
I
unbalanced mic or line level inputs to these 3-pole Mic/Line captive screw connectors
These inputs support optional +48 VDC phantom power, which is indicated by the LEDs
at the left of the connectors.
Analog audio line output connectors 1 through 4 — Connect balanced or
J
unbalanced analog audio output devices to one or both 5-pole captive screw audio
output connector pairs 1 and 2 or 3 and 4 (see
page 19).
ATTENTION:
•
For unbalanced audio, connect the sleeves to the ground contact. Do not
connect them to negative (–) contacts.
•
Pour l'audio asymétrique, connectez les manchons au contact au sol. Ne
PAS connecter les manchons aux contacts négatifs (–).
•
The length of the exposed wires in the stripping process is critical. The ideal
length is 3/16 inch (5 mm). If the exposed portion is longer, the wires may
touch, causing a short circuit between them. If the exposed wires are shorter,
they can be easily pulled out, even if tightly fastened by the captive screws.
•
La longueur des câbles exposés est primordiale lorsque l'on entreprend
de les dénuder. S'ils sont un peu plus longs, les câbles exposés pourraient
se toucher et provoquer un court circuit. S'ils sont un peu plus courts, ils
pourraient sortir, même s'ils sont attachés par les vis captives.
•
Do not tin the wires. Tinned wire does not hold its shape and can become
loose over time.
•
Ne pas étamer les câbles. Les câbles étamés ne sont pas aussi bien fixés
dans les terminaisons des connecteurs à vis captives et pourraient sortir.
IN1806 and IN1808 Series Scaling Presentation Switchers • Installation
on page 13). Figure 7 shows how to wire the
Tx
Rx
G
IR Device
on page 48).
figure 3
Analog Audio Connections
figure 3
Ethernet to
and
figures 4 through
6).
figure 10
on
on
16
Advertisement
Table of Contents
