Front Panel Lockout (Executive Modes) - Extron electronics IN1806 Series User Manual

•
•
•
•

Front Panel Lockout (Executive Modes)

The IN1806 and IN1808 Series scalers have five modes of front panel security lock that limit
the operation of the device from the front panel. When the front panel controls are locked,
RS-232, USB, and Ethernet control remain operational.
NOTE: All lock modes persist after a power cycle.
The front panel lock mode can also be selected using SIS commands (see the
Lock (Executive Mode) commands
Series PCS Help file).
The following table shows the functionality that is in place for each mode:
•
•
•
•
•
DHCP Mode — When this mode is enabled (
other network settings from the DHCP server. The default is
To enable or disable DHCP mode:
1. Select from the
DHCP Mode
>
2. Press the and < button to select
You can also set the DHCP mode via an SIS commands (see the
commands on page 82), the PCS software, or the internal web page (see
Settings Panel on page 109).
IP Address — Press the
>
Press the and < buttons to adjust the value of the selected octet. The default is
.
192.168.254.254
Subnet Mask — Press the
>
address. Press the and
default is
255.255.255.0
Gateway — Press the

>
<
Press the and buttons to adjust the value of the selected octet. The default is
.
0.0.0.0
Lock Mode Input Switching
0 Unlocked
1 Locked
2 Unlocked
3 Unlocked
4 Locked
Mode 0 — Unlocks front panel functions. This is the default setting.
Mode 1 — Locks all front panel functions. Pressing the
causes the message
Executive Mode 1 Enabled
can be enabled or disabled only via SIS commands and PCS.
Mode 2 — Locks all front panel functions except input switching, logos, and volume
control. Pressing the
Menu
to appear on the display. To enable lock mode 2, press and hold the
Enabled
buttons simultaneously for 2 seconds.
Enter
Mode 3 — Locks all front panel functions except input switching and logos.
Mode 4 — Locks all front panel functions except volume control.
IN1806 and IN1808 Series Scaling Presentation Switchers • Operation
), the unit obtains an IP address and
On
submenu and press
Communications
or and press
On Off
and buttons to select an octet of the IP address.
 u
and buttons to select an octet of the subnet mask
 u
< buttons to adjust the value of the selected octet. The
.
and buttons to select an octet of the gateway address.
u
on page 77) and PCS (see the IN1806 and IN1808
Logos
Unlocked
Locked
Unlocked
Unlocked
Locked
to appear on the display. This mode
button in this mode causes the message
.
Off
.
Enter
again.
Enter
DHCP mode
Network
Front Panel
Volume Adjustment
Unlocked
Locked
Unlocked
Locked
Unlocked
button in this mode
Menu
Executive Mode 2
Menu
and
44