Connection Details; Analog Video Wiring; Hdmi Connections - Extron electronics IN1604 DT User Manual

Connection Details

Analog Video Wiring

Pin

HDMI Connections

Pinout Table for 15-pin HD Connectors
RGBHV
1 Red
2 Green
3 Blue
4
5 H Sync Return C Sync Return
6 Red Return
7 Green Return
8 Blue Return
9
10 V Sync Return/
DDC Return
11
12 EDID/DDC
13 H Sync
14 V Sync
15 EDID/DDC
Use an Extron LockIt lacing bracket to secure an HDMI
cable to each device.
1.
Plug the HDMI cables into the panel connection
(see of the image to the right).
1
2. Loosen the side HDMI connection mounting screw
from the panel enough to allow the LockIt lacing
bracket to be placed over it (
not have to be removed.
3. Place the LockIt lacing bracket on the screw and
against the HDMI connector, then tighten the screw
to secure the bracket (
Do not overtighten the HDMI connector mounting screw. The
ATTENTION:
shield to which it is fastened is very thin and can easily be stripped.
ATTENTION : Ne serrez pas trop la vis de montage du connecteur HDMI. Le
blindage auquel elle est attachée est très fin et peut facilement être dénudé.
4. Loosely place the included tie wrap around the HDMI connector and the LockIt
lacing bracket ( ).
4
5. While holding the connector securely
against the lacing bracket, use pliers or
a similar tool to tighten the tie wrap,
then remove any excess length.
The LockIt bracket can also be used in a
stacked formation, as shown right.
RGBs Component
Red R-Y
Green Y
Blue B-Y
Red Return R-Y Return
Green Return Y Return
Blue Return B-Y Return
DDC Return
EDID/DDC
C Sync
EDID/DDC
). The screw does
2
).
3
Side Mounted
IN1604 DTP and IN1604 HD Scalers • Installation
S-video Composite
Luma Video
Chroma
L Return Video Return
C Return
5 1
15
11
1
2
3
4
Stacked
11