Connection Details - Extron electronics XTP T USW 103 User Manual

H
I

Connection Details

HDMI Connection
To secure the HDMI cable to the HDMI input connector, use an Extron LockIt Cable Lacing
Bracket and a tie wrap.
1
Figure 5.
1.
2.
3.
4.
5.
Remote RS-232 connector — Connect a host device to the 3.5 mm, 3-pole captive
screw connector (see figure
RS-232
Tx Rx G
Do not tin the wires!
Bidirectional
Ground (G)
Receive (Rx)
Transmit (Tx)
Figure 4. Remote RS-232 Wiring
Power connector and LED — Connect the external 12 V, 1.0 A power supply to
the 2-pole captive screw connector (see
considerations, see Power Connection
indicate the device is receiving power.
NOTE: The XTP T USW 103 can also be powered remotely (see
on page 13).
3
2
Installing the LockIt Cable Lacing Bracket
Plug the HDMI cable into the panel connection (see figure 5,
Loosen the HDMI connection mounting screw from the panel (
LockIt to be placed over it. The screw does not have to be removed.
Place the LockIt on the screw and against the HDMI connector (
the screw to secure the bracket.
Loosely place the included tie wrap around the HDMI connector and the LockIt (
While holding the connector securely against the cable lacing bracket, use pliers or
similar tools to tighten the tie wrap, then remove any excess length (
ATTENTION:
• Connect and pull the tie wraps until they are secure. Do not overtighten.
• Connectez et tirez les serre-câbles jusqu'à ce qu'ils soient sécurisés. Ne pas
trop serrer.
2, on page 4) for serial control of the switcher.
H
Controlling
Device
Ground (G)
Receive (Rx)
Transmit (Tx)
figure 2,
I
on page 11. The Power LED lights to
4
3
5
XTP T USW 103 Switcher • Installation
on page 4). For wiring
Remote power
).
1
) enough to allow the
2
), and then tighten
3
4
).
5
).
7