Entry For Traversing Programs - Siemens SIMATIC S7-300 Manual

Input of traversing An empty window is provided for the input of NC traversing programs. Here
programs
you can input your traversing program as follows:
Fig. 5-7
1. % Program number Program name
2. N<block number> – G<command> (G1, G2, G3) – X<value> – F<value>
You must enter characters in upper case letters.
You can also use the input area at the top of the screen. The program number
and the program name are saved when you exit the input box. You can save
the traversing blocks with the "Save Block" button.
FM 354 Servo Drive Positioning Module

Entry for traversing programs

The "%" can be input only in the first line. This input is mandatory. The
DB number is formed from the program number.
The program name is optional and may have up to 18 characters.
– M<command> (M1, M2, M3) – D<No.> (tool offset number) – L<No.>
– P<No.> ± (for NC programming see Chapter 10).
– You must enter the block number (N) first and in ascending order.
The rest of the inputs may be in any desired sequence.
– Input separators as a blank.
Defining Parameters of the FM 354
5-21