Siemens SIMATIC S7-300 Manual page 313

Table 11-8 General data errors, machine data errors, traversing program errors, continued
Cl. No.
Traversing program errors Error response: "Warning" see Table 11-2
8 (08) 24 (18) G function 1 unacceptable
Cause
Effect
Elimina-
tion
8 (08) 25 (19) G function 2 unacceptable
Cause
Effect
Elimina-
tion
8 (08) 26 (1A) G function 3 unacceptable
Cause
Effect
Elimina-
tion
8 (08) 27 (1B) M function unacceptable
Cause
Effect
Elimina-
tion
8 (08) 28 (1C) Position/dwell time missing
Cause
Effect
Elimina-
tion
Cl. = Detail event class, No. = Detail event number, CBS = checkback signals, DB = data block
Note: Value (xx) = Hexadecimal notation of the error number
FM 354 Servo Drive Positioning Module
Error message,
error analysis and elimination
The number programmed as G function 1 is not allowed.
In block, other data besides M-functions were programmed
with dwell time (G04).
Program/block not stored
Correct program, per cause
The number programmed as G function 2 is not allowed.
Program/block not stored
Correct program, per cause
The number programmed as G function 3 is not allowed.
External block change (G50) was programmed in a block to-
gether with continuous operation for setting actual value
on the fly (G88/89).
A tool offset (G43, G44) was called up without D number.
In selecting a D number, the direction specification is missing
for the tool offset (G43, G44).
Program/block not stored
Correct program, per cause
The number programmed as M function is not allowed.
At least two of the M functions M0, M2, M18, M30, which
cancel each other out, are found in one block.
Program/block not stored
Correct program, per cause
No dwell time specified in block with G04.
Target position missing with external block change (G50).
No new actual value programmed for the function continuous
operation with setting actual value on the fly (G88/89).
Program/block not stored
Correct program, per cause
Troubleshooting
Message/
Display
CBS
or
DB
CBS
or
DB DB
CBS
or
DB
CBS
or
DB
CBS
or
DB
11-33