Siemens SIMATIC S7-300 Manual page 158

Human-machine interface
Table 8-1 below describes the individual screens of the user interface.
Table 8-1 Description of the screens in the user interface
Screen name Screen
Main screen PIC7
Main screen, actual value PIC71
display
Main screen, startup PIC72
Main screen, diagnostics PIC73
User screens PIC74
and
PIC724
Setting data for operating PIC712
mode
Setting data for the "Au- PIC713
tomatic" operating mode
Set actual value PIC714
8-6
No.
This screen is displayed to you after the OP 07 is enabled. The FM354 values
are display values. You can use the soft keys to call up the following main
screens:
Softkey "Istw"
Softkey "IBN"
Softkey "Diag"
Softkey "Anw"
The values on the screen are display values. You can use the soft keys to call
up the following screens:
Softkey "Teach"
Softkey "BA-E"
Softkey "Auto"
Softkey "Eist" PIC714
The FM 354 values (service data) are display values. You can use the soft
keys to call up the following screens:
Softkey "MD"
Softkey "Eins"
Softkey "Anw"
This screen shows you the diagnostic interrupts and error messages for the
FM 354 in four lower-level screens. The following are displayed:
Error class and error number for operator control and guidance errors
The bit numbers of the single diagnostic interrupt bytes
You can use the soft keys "Quit" and "Res" to acknowledge the errors.
See Section 11.3 for diagnostic interrupts and error messages
You can use these screens to configure your own contents.
This screen contains input/output fields for the velocity levels or a text field
for selecting velocity level (selections 1 or 2 possible). You can use the soft
keys to call up the following screens:
Softkey "Steu"
Softkey "SMR"
Softkey "MDI"
This screen contains only display fields. You can use the "Anwahl" soft key
to call up screen PIC 7132.
The actual value display is a display field. The value for set an actual value
appears in an input/output field. You can use the soft key "NPVer" to call up
the screen PIC7141. You can use the soft keys "Iwrü" and "IWset" to execute
functions.
Description
PIC71
PIC72
PIC73
PIC74
PIC711
PIC712
PIC713
PIC722
PIC723
PIC724
PIC7122
PIC7123
PIC7124
FM 354 Servo Drive Positioning Module