Siemens SIMATIC S7-300 Manual page 154

Human-machine interface
What can I control Using the keyboard of the operator panel, you can change the data/signals in
on the FM 354?
the data blocks:
What can I monitor The following data and signals can be displayed on the operator panel dis-
on the FM 354?
play:
The configuration package includes a pre-configured interface for the CO-
ROS OP 07 and OP 17 operator panels.
Chapter over-
view
8.1
8.2
8.3
8-2
Machine data DB No. 1200
Increment sizes DB No. 1230
Tool offset data DB No. 1220
Traversing programs DB No. 1001...1199
Machine data DB No. 1200
Increment sizes DB No. 1230
Tool offset data DB No. 1220
Traversing programs DB No. 1001...1199
Status messages DB No. 1000 (DB-SS) etc.
– Operating data, such as actual values
– Active NC blocks
– Linear measurements
– Actual value block change
– Check-back signals and error conditions
– Service data
In Section
Standard user interface for the OP 07 and the OP 17
Evaluation of the user DBs by the user program
Data block for status messages (DB-SS)
you will find
FM 354 Servo Drive Positioning Module
on page
8-3
8-16
8-20