User Db - Siemens SIMATIC S7-300 Manual

Defining Parameters of the FM 354
User data block Chapter 6 describes how to generate a user data block.
You can use "Parameterize FM 354" to fill the user DB with the data de-
scribed in Table 5-2.
The menu Target system Online editing
and edit your user DB.
Table 5-2

User DB

1) You can only view these data. The data are edited by the FC INIT_DB (see Chapter 6).
5-8
User DB
Data block
For the structure and data formats see Chapter 6
You can preload the following data to the DB provided the DB
itself has been loaded to the CPU:
Module address
Channel address
Channel offset
Zero offset
Set actual value
Set actual value on-the-fly
Set reference point
Setpoint for increment
Speed Level 1
Speed Level 2
Voltage Level 1
Voltage Level 2
MDI block
MDI block on the fly
Program selection, program number
Program selection, block number
Program selection, working direction
Code application data 1
Code application data 2
Code application data 3
Code application data 4
User data allows you to select
Significance
1)
1)
Reserved
FM 354 Servo Drive Positioning Module