Siemens SIMATIC S7-300 Manual page 95

The following read jobs (JOB_RD.NO) are known:
Legend for the table below:
Operating mode:
Operating modes
System data
Display data is data/parameters returned by the FM.
DIG_IO – dig. inputs/outputs
OP_DAT – basic operating data
ACT_BLCK – active NC block
NXT_BLCK – next NC block
APP_DAT – application data
BLCK_EXT – actual value block
change
SERV_DAT – service data
SRV_OUT – reserved
OP_DAT1 – additional operating data
PAR_READ – parameters/data
Data is accepted and only processed in the corresponding mode.
x Data is accepted or processed, as applicable.
– Data are rejected with error message (see Troubleshooting, Table 11-5 Class 4 No. 1).
FM 354 Servo Drive Positioning Module
T – Jogging
STE – Open–loop control
REF – Reference point approach
SM – Incremental relative
MDI – MDI (Manual Data Input)
A/AE – Automatic/Automatic single block
Job no.
Addr. in
T STE
user DB
101 150.0 x
102 198.0 x
103 230.0
104 250.0
105 270.0 x
107 286.0
108 290.0 x
109 322.0
110 354.0 x
114 366.0 x
Programming the FM 354
REF SM MDI A/AE
x x x x x
x x x x x
x
x
x x x x x
x
x x x x x
x x x x x
x x x x x
see
Sec-
tion
9.8
9.3.11
9.3.12 9 3 12
9.3.13
9.3.14
9.3.15
9.3.16
9.3.17
6-15