Siemens SIMATIC S7-300 Manual page 44

Wiring the FM 354
Procedure for To connect the encoders:
connecting
1. Connect the connecting cables to the encoders.
encoders
2. Open the front door and plug the sub-D connector into the module.
3. Lock the connector in place with the knurled screws. Close the front door.
Available
Cable set for add-on encoders or EXEs (for connection of linear scales)
connecting cables
Order No.:
for encoders
Cable set for built-in encoders with 17-pin round plugs.
Order No.:
Cable set for absolute encoders (SSI) with a free cable end.
Order No.:
Connecting cables are available in a variety of lengths.
see
4-12
For absolute encoders (SSI) it may be necessary to cut and add connectors
to the cable (end of the cable to the encoder) according to the manufactur-
er's instructions.
6FX2 002-2CD01-1
6FX2 002-2CE01-1
6FX2 002-2CC01-1
Order No.: E86060-K4490-A001-A4.
0
0
0
FM 354 Servo Drive Positioning Module