Siemens SIMATIC S7-300 Manual page 326

Index
dimensions, 10-8
dimensions of the FM 354, A-3
direction alignment, 9-77
direction of machining, 9-30
drift compensation, 7-25, 9-75
deactivation, 9-41
drive enable, 9-4
drive time constant, 7-15, 7-19
drive unit, 4-6, 7-12
dwell, 10-4
E
EMC guidelines, 4-1
encoder, 7-12
actual encoder value, 9-54
encoder inputs, A-3
encoders, 4-7, 4-9, 9-59
absolute encoders, 4-8, 9-64
connecting the encoders, 4-11
incremental encoders, 4-8, 9-61
error acknowledgment, 6-12
error class, 11-3
external channel errors, 11-3
external errors, 11-3
internal errors, 11-3
error evaluation , 7-9
error list, 11-10
data errors, 11-22
external channel errors, 11-12
external errors, 11-11
internal errors, 11-10
machine data errors, 11-27
operator control errors, 11-14, 11-16
travel errors, 11-18
traversing program errors, 11-31
error messages, 11-4
LED indicators, 11-4
error response, 11-3
external block change, 10-4
F
FM approval, A-2
FM cycle, 9-19, 9-39, 9-51, 9-79, 9-80, A-3
follow–up mode, 9-40
following error monitoring, 9-73
front connector, 1-8, 4-13
connecting cables, 4-18
wiring the front connector, 4-18
front connectors, 4-3
Index-2
front–panel elements, 1-8, 1-9
LED indicators, 1-9
G
G functions, 10-3
I
I/O interface, 4-13
incremental dimensioning, 10-8
incremental encoders, 4-8, 9-61
measured value synchronization, 9-68
Incremental relative, 9-9
incremental relative, 9-22
increments, 5-17
inprocess measurement, 9-50
Installing the FM 354, 3-2
interfaces, 4-13
I/O interface-interfaces, 4-13
interpolator, 9-70
interrupts, 9-83
J
Jogging, 9-9, 9-13
jolt filter, 7-20, 9-71
L
length measurement, 9-51
linear axis, 9-57
M
M functions, 10-13
machine data, 5-9
activate, 9-42
activation, 7-11
dependencies, 5-14
input limits, 7-3
interdependencies, 7-3
machine data list, 5-11
MDI (Manual Data Input), 9-9, 9-25
measured values, 6-22, 9-50
inprocess measurement, 9-50
length measurement, 9-51
measurement, 9-50
mode parameter, 9-13, 9-16
FM 354 Servo Drive Positioning Module