Siemens SIMATIC S7-300 Manual page 51

Tools required A 3.5 mm (.13 inches) screwdriver or power screwdriver.
Procedure for
To wire the terminal strip:
wiring the front
1. Strip 6 mm (.23 inches) of insulation from the cable; apply ferrules,
connector
2. Open the front door. Move the front connector into position for wiring
3. Apply the cable grip to the connector.
4. If you are leading the lines out from below, start wiring from the bottom;
5. Tighten the cable grip on the cable strand.
6. Move the front connector into operating position (while pressing down on
7. You can fill out the labeling strip enclosed with the product and slip it
Shielded cables When using shielded cables, the following additional steps are necessary:
1. After leading the cable into the cabinet, connect the cable shielding with a
2. Connect the shielded line to the module, but do not connect the shielding
Shielding terminal
To provide a shielding end lead for shielded cables, this element can be in-
element
serted in the DIN rail. It can accept up to eight shielding terminals
(KLBÜ line from Weidmüller).
Order No.:
see Catalog NC 60.1, Order No. E86060-K4460-A101-A3
see Catalog ST 70, Order No. E86060-K4670-A101-A2
FM 354 Servo Drive Positioning Module
if any.
(while pressing down on the locking elements as shown in Figure 4-6).
Lock the connector in place without any electrical contact to the module.
otherwise start from the top. Screw down unused terminals as well.
The tightening torque should be 60-80 Nm.
the locking elements).
into the front panel.
grounded shielding bus (strip the insulation from the cable itself).
For this you can use the shielding terminal element mounted on the DIN
rail; it will accept up to eight shielding terminals.
see manual S7-300 Programmable Controller, Hardware and Installation,
Order No.: 6ES7 030-0AA01-8AA0.
there.
Terminal element: 6ES7 390-5AA00-0AA0
Shielding terminal: 6ES7 390-5CA00-7AA0
Wiring the FM 354
4-19