Startup Interface (E.g. For "Reference-Point Approach" Mode) - Siemens SIMATIC S7-300 Manual

When you call up this menu the following screen appears:
1
2
3
1 – Error field
2 – Status field (e.g. actual values, check-back signals)
3 – Field for mode-specific inputs
4 – Field for input of values/settings/commands and start/stop for movement
The abbreviations for the checkback signals are described in Section 6.2.2.
Fig. 7-2

Startup interface (e.g. for "Reference-point approach" mode)

FM 354 Servo Drive Positioning Module
Starting up the FM 354
4
7-7