Siemens SIMATIC S7-300 Manual page 307

Table 11-8 General data errors, machine data errors, traversing program errors, continued
Cl. No.
General data errors
4 (04) 128 (80) Incorrect module identification
Cause
Effect
Elimina-
tion
4 (04) 129 (81) Incremental value, incorrect value
Cause
Effect
Elimina-
tion
4 (04) 130 (82) Tool offset, incorrect value
Cause
Effect
Elimina-
tion
4 (04) 131 (83) Not possible to insert block
Cause
Effect
Elimina-
tion
4 (04) 132 (84) Not possible to delete block
Cause
Effect
Elimina-
tion
Machine data errors
5 (05) 7 (07) Measurement system
Cause
Effect
Elimina-
tion
Cl. = Detail event class, No. = Detail event number, CBS = checkback signals, DB = data block
Note: Value (xx) = Hexadecimal notation of the error number
FM 354 Servo Drive Positioning Module
Error message,
error analysis and elimination
Error response: "Warning" see Table 11-2
DBs which do not belong to the module were transmitted
(no identification 354)
DB does not become effective and is stored non-retentively
Transmit the DBs belonging to the FM 354
9
Value range outside 10
Incremental value not effective
Transmit correct value
9
Value range outside 10
Tool offset not effective
Transmit correct value
Memory full
Function is not executed
Delete unnecessary DBs and repeat function
Block does not exist, no "assignment bits (bytes 2 and 3) enabled in
block (when data available).
Function is not executed
Check program and repeat function with correct block number
Error response: "Warning" see Table 11-2
The measurement system grid (MSR) entered does not agree with
the MSR in the other DBs of the module.
DB does not become effective and is stored non-retentively
Check MSR and correct as necessary
When making correct input, delete the other DBs on the mod-
ule before retransmitting.
Troubleshooting
Message/
Display
CBS
or
DB
CBS
or
DB DB
CBS
or
DB DB
CBS
or
DB DB
CBS
or
DB
CBS
or
DB
11-27