Comtech EF Data LPOD PS-1 Installation And Operation Manual page 64

LPOD C-/Ku-Band Outdoor Amplifier / Block Up Converter (BUC)
Remote Commands
Command
(Instruction
Parameter Type
Code and
Qualifier)
*Terminal Status N/A
Change
Reboot RBT=
Unit MAC N/A
Address
Arguments for
Description of arguments
Command or
(Note that all arguments are ASCII numeric codes: i.e.,
Response to
ASCII codes between 48 and 57)
Query
1 byte Query only.
Indicates if there has been a change in the
configuration since the last time the command was
given. A value of 0 indicates no status change, and a
value of 1 indcates there has been a configuration
change. A status change is defined as any time a
command is successfully executed. A query does not
set the status change flag. The status change flag is
cleared after being read. No other events toggle a
status change.
Example: <1/TSC?
>0001/TSC=0'cr''lf'
1 byte Soft Reboot
1 = Reboot System
17 bytes Query only.
MAC address of the unit, reported in hexadecimal.
Example: MAC=00-06-B0-00-D2-A7
Response to
(Target to controller)
RBT = (message ok)
RBT? (received ok, but
invalid arguments
found)
RBT* (message ok, but
not permitted in current
mode)
MAC= (message ok)
MAC* (message ok, but
not permitted in current
mode)
3–30
Query
(Instruction
Command
Code and
qualifier)
N/A TSC?
N/A
N/A
Revision 0
MN-LPOD
Response to
query
(Target to
controller)
TSC=x
(See description
for details of
arguments)
RBT=x
(See description
for details of
arguments)
MAC=xx-xx-xx-
xx-xx-xx
(See description
for details of
arguments)