Comtech EF Data LPOD PS-1 Installation And Operation Manual page 60

LPOD C-/Ku-Band Outdoor Amplifier / Block Up Converter (BUC)
Remote Commands
Command
(Instruction
Parameter Type
Code and
Qualifier)
*Retrieve Number N/A
of unread
Stored Alarms
Number of N/A
Unread stored
Events
Initialize Events IEP=
Pointer
*Retrieve Utility N/A
Status
Arguments for
Description of arguments
Command or
(Note that all arguments are ASCII numeric codes: i.e.,
Response to
ASCII codes between 48 and 57)
Query
2 bytes Query only.
Returns the number of stored events, which remain
unread in the alarm log. A maximum of 255 events
may be stored in the alarm log. Numbers over 99 will
be reported as 99.
Example reply: <1/TNA? 'cr'
>0001/TNA=14'cr''lf'
Note: A reply of TNA=* indicates that there are no
events in the log.
3 bytes Query only.
Unit returns the Number of stored Events, which
remain Unread in the form of xxx.
Example: NUE=126
None Command only.
Resets internal pointer to allow RNE? Queries to start
at the beginning of the stored events log.
Example: IEP=
23 bytes, Query only.
alpha- numeric Used to Query the utility status of the unit.
Example: <1/RUS='cr'
>0001/RUS='cr'
ADR=0001'cr'
BDR=09600'cr'
*REF=087'cr''lf'
*Note: REF will only appear if a reference oscillator is
installed.
Response to
(Target to controller)
IEP= (message ok)
IEP? (received ok, but
invalid arguments
found)
IEP* (message ok, but
not permitted in current
mode)
3–26
Query
(Instruction
Command
Code and
qualifier)
N/A TNA?
N/A NUE?
N/A
N/A RUS?
Revision 0
MN-LPOD
Response to
query
(Target to
controller)
TNA=xx
(See description
for details of
arguments)
NUE=xxx
N/A
RUS=x....x
(See description
for details of
arguments)