Locating Event Records - Arbiter Systems Portable Power Sentinel 933A Operation Manual

3. You can reduce or increase the rate at which you can search through
records by pressing the REDUCE RATE or INCREASE RATE soft
keys.
4. Press the numeric key that corresponds to the data record you wish
to review.
5. Press the numeric key corresponding to the data type from the
DISPLAY SELECTIONS screen to view the actual data record.
Press any other numeric key to change the data type.
5.2.2

Locating Event Records

To find the event record information in the 933A, proceed as follows:
1. Press the keys, REVIEW > SHOW USER, or SHOW PWR QUAL
2. Press the REDUCE RATE or INCREASE RATE soft keys if
necessary.
3. Press the numeric key that corresponds to the event record you wish
to review. Notice that the event record always indicates the trigger
by number and whether it is active (up arrow) or inactive (down
arrow).
4. The next screen will always show the high-speed waveform record
of the event, and within 50 ms of the event. Remember that there
should be either 25 or 30 cycles of pre-event data.
5.2.3 Reviewing Recorded Data (Show Log)
To view any recorded data (following an Event or LOG key press, or
Autolog session) press the keys:
REVIEW > SHOW LOG > REVIEW SELECTIONS > (EVENT LOGS,
KEY LOGS, AUTO LOGS or ALL LOGS)
Press the soft key corresponding to the type of data you wish to review.
This does two things: (1) it opens the specific data record selection window,
and (2) returns you to the previous menu. From here you can review a
record, choose other record types to review, press the REDUCE RATE or
INCREASE RATE soft keys to improve record searches.
Figure 5.2 below shows how the 933A sorts the data records according to
type. If you choose SHOW EVENT LOGS, only the Event records would
64