Contents and general instructions
Intended use
Target group
Service
Festo P.BE−CPX−PN IO−EN en 0710NH
The CPX−FB33 and CPX−FB34 bus nodes documented in this
description are only intended for use as participants
(I/O device) on PROFINET IO.
The CPX terminal must only be used as follows:
as designated in industrial applications.
in original condition without modification (only the con
versions or modifications described in the documentation
supplied with the product are permitted).
in faultless technical condition.
The maximum values specified for pressures, temperatures,
electrical data, torques etc. must be observed.
If additional commercially available components such as
sensors and actuators are connected, the specified limits for
pressures, temperatures, electrical data, torques, etc. must
not be exceeded.
Also observe the standards specified in the relevant chapters,
as well as national and local laws and technical regulations.
This manual is intended exclusively for technicians trained in
control and automation technology who have experience in
installing, commissioning, programming and diagnosing
slaves on PROFINET.
Please consult your local Festo Service agent if you have any
technical problems.
V