Festo CPX-FB33 Manual page 21

1. Installation
Dismantling
1
CPX bus node
(example CPX−FB33)
2
Manifold base
3
Contact rails
4
Torx T10 screws
Fig. 1/2: Dismantling/installing the bus node
Festo P.BE−CPX−PN IO−EN en 0710NH
Dismantling and fitting
The bus node is installed in a manifold base of the
CPX terminal (see Fig. 1/2).
Dismantle the bus node as follows:
1. Undo the four screws of the bus node with a Torx screw
driver size T10.
2. Pull the bus node carefully and without tilting away from
the contact rails of the manifold base.
4
3
Note
Whether the manifold base is metal or plastic, always use
the suitable screws for the manifold base
for plastic manifold bases: thread−cutting screws
for metal manifold bases: screws with metric thread.
1
2
1−5