Procedure For Replacing A Bus Node - Festo CPX-FB33 Manual

Cpx bus node. network protocol profinet io
Hide thumbs Also See for CPX-FB33:
Table of Contents

Advertisement

2. Commissioning

2.1.6 Procedure for replacing a bus node

Replacing the
memory card
2−28
Easy replacement using memory card
The memory card is used as a carrier of configuration data,
e. g. of the field bus device name (PROFINET IO Device
Name). Thus, a bus node can be conveniently replaced.
Caution
Risk of malfunctions or damage.
Inserting or removing the memory card while the power
supply is switched on can result in malfunctions of or
damage to the memory card.
Disconnect the power supply before you insert or
·
remove the memory card.
The memory card is under a cover (see Fig. 1/1). You need a
screwdriver in order to remove or fit this cover.
Procedure
1. Switch off the power supply.
2. Remove the cover (observe section 1.2.1).
3. Remove the memory card from the bus node.
4. Replace the bus node (Installation/Dismantling:
see section 1.1).
5. Insert the memory card in the new bus node.
6. Replace the cover (observe section 1.2.1).
7. Switch on the power supply.
8. Start the automation program if necessary.
9. The controller recognises the bus node using the device
name on the memory card and loads all required data.
Festo P.BE−CPX−PN IO−EN en 0710NH

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cpx-fb34

Table of Contents