Use Of The Memory Card - Festo CPX-FB33 Manual

1. Installation

1.2.3 Use of the memory card

Replacing the
memory card
1−14
The memory card is used as a carrier of configuration data,
e. g. of the field bus device name (PROFINET IO Device
Name). Thus, a bus node can be conveniently replaced.
Note
Data stored on the card have priority over other configur
ation data which are stored, e.g. in the bus node memory
or in the controller system (see also section 2.2.1,
sequence of the start parameterisation with memory card).
Caution
Risk of malfunctions or damage.
Inserting or removing the memory card while the power
supply is switched on can result in malfunctions of or
damage to the memory card.
Disconnect the power supply before you insert or
·
remove the memory card.
The memory card is under a cover (see Fig. 1/1). You need a
screwdriver in order to remove or fit this cover.
Bus node replacement procedure
1. Switch off the power supply.
2. Remove the cover (observe section 1.2.1).
3. Remove the memory card from the bus node.
4. Replace the bus node.
5. Insert the memory card in the new bus node.
6. Replace the cover (observe section 1.2.1).
Festo P.BE−CPX−PN IO−EN en 0710NH