Festo CPX-FB33 Manual page 46

2. Commissioning
Configuration of the
bus node
Module (order code)
FB33:
Bus node for PROFINET IO,
2 x M12 socket, metal version
FB34:
Bus node for PROFINET IO,
2 x RJ45 socket, metal version
1)
Module identifier in the hardware configuration of the programming software
Note: In the handheld, the bus node is basically designated as ProfiNet Remote I/O"
(independent from the operating mode)
Tab. 2/2: Configuration of the bus node for the operating mode Remote Controller
2−6
The identification of the bus node and the diagnostics mode
are configured in the Remote I/O operating mode
(see Tab. 2/1).
In the Remote Controller operating mode only the identifier
of the bus node will be configured (see section Tab. 2/2):
Module identifier
FB33−RC
FB34−RC
1)
Occupied IO bytes
FB33/34 in the operating mode
Remote Controller:
8 bytes I, 8 bytes O
Festo P.BE−CPX−PN IO−EN en 0710NH