Example configuration
Overview
The commissioning described in this manual orientates itself on an example configuration of
the SINAMICS drive line-up.
The following figure roughly shows the components.
● An NCU 710 with:
● An NX 15 with:
● An Active Line Module
IBN CNC: NCK, PLC, drive
Commissioning Manual, 07/2007, 6FC5397-2AP10-3BA0
– A Single Motor Module for a motor with SMI (Sensor Module Integrated)
– A Double Motor Module for two motors each with an SMC 20 (Sensor Module
Cabinet)
– A Single Motor Module for a motor with two SMC 20 for the encoder
4
29