Check Topology - Siemens SINUMERIK 840D sl Commissioning Manual

Tips
13.7 Extending/checking the topology
13.7.2

Check topology

Introduction
After you have parameterized the drive components, you can view the topology on the HMI.
Topology of individual drive components
1. Under "Commissioning", press the "Drive system > Drive units > Topology" softkeys one
after the other.
2. On the HMI, the topology of individual drive components is displayed, including the
component number (see figure below).
Figure 13-30 Topology
You will need the component numbers in order to configure direct measuring systems
manually.
250
You can now check whether the topology displayed conforms with the topology of your
system.
Commissioning Manual, 07/2007, 6FC5397-2AP10-3BA0
IBN CNC: NCK, PLC, drive