Integrating Pg/Pc Into The Network (Netpro) - Siemens SINUMERIK 840D sl Commissioning Manual

Tips

13.4 Integrating PG/PC into the network (NetPro)

13.4 Integrating PG/PC into the network (NetPro)
Introduction
To carry out routing functions, it is necessary to integrate a PG/PC in the SIMATIC Manager
under NetPro and to configure the interfaces.
Requirements
You have to have carried out the following as laid out in the previous chapters:
● inserted NCU 720.1 into the HW config,
● configured the properties of the network interfaces,
● configured the PLC to drive communication,
● inserted the machine control panel (MCP),
● saved and compiled the configuration,
● created a PLC program.
See also
Insert NCU 7x0 in HW config (Page 43)
Configuring the properties of the network interfaces (Page 44)
Adding a machine control panel and handwheel in HW Config (Page 262)
End hardware configuration and load to the PLC (Page 50)
Creating a PLC program (Page 51)
222
Commissioning Manual, 07/2007, 6FC5397-2AP10-3BA0
IBN CNC: NCK, PLC, drive