Enabling/Disabling Sinumerik Plug-Ins - Siemens SINUMERIK 840D sl Commissioning Manual

Licensing
14.9 Assigning via Automation License Manager
14.9.3

Enabling/disabling SINUMERIK plug-ins

Background
All of the plug-ins enabled for the Automation License Manager scan the relevant
communication interfaces when booting and after specific operator inputs. If there is a large
number of enabled plug-ins, this can result in a significantly longer boot and refresh time for
the user interface. To prevent this delay, you can disable the plug-in installed for handling
the SINUMERIK License Keys in dialog: "Connect to target system".
Procedure
Perform the following actions to enable/disable the SINUMERIK plug-ins:
1. Start the Automation License Manager
2. Open the "Connect to target system" dialog via menu command: Edit > Connect to target
system > SINUMERIK . . .
3. In the dialog, open tab: Settings
4. Enable/disable the plug-in by selecting/deselecting the appropriate checkbox.
5. Close the dialog by pressing the button: OK
Result
The Automation License Manager shows the SINUMERIK-specific license information in
accordance with the current status of the SINUMERIK plug-in. See Section:
Note
How to refresh the view manually
If the view is not automatically refreshed, you can refresh the view manually. See Section:
"How to refresh the view: Manage"
276
Commissioning Manual, 07/2007, 6FC5397-2AP10-3BA0
IBN CNC: NCK, PLC, drive