Handling The Machine Data - Siemens SINUMERIK 840D sl Commissioning Manual

Fundamentals
15.5 Machine and setting data
15.5.2

Handling the machine data

Introduction
To display and input machine data, appropriate screen forms are provided.
Example
Selection of displays:
When yóu press the Area Switchover key on the HMI, the menu bar appears with the
following areas: Machine, Parameter, Program, Services, Diagnostics and Installation and
Start-Up. Press Installation and Start-Up and then Machine data.
Note
For the input of machine data, the protection level 2 password "EVENING" has to be set at
the least.
Screen editor for HEX machine data
A bit editor has been implemented to simplify the matter of setting certain machine data bits.
If the input cursor is on a machine data in HEX format in the MD list, you can call up the
editor by pressing the toggle key (in the middle of the cursor keys).
You can set or reset single bits by clicking them with the mouse or by selecting them with the
cursor keys and then pressing the toggle key.
● With the soft key OK, you can terminate the bit editor and accept the value set.
● With the soft key Abort, you can quit the bit editor and discard the value set. The previous
314
setting is then valid again.
Commissioning Manual, 07/2007, 6FC5397-2AP10-3BA0
IBN CNC: NCK, PLC, drive