Siemens SINUMERIK 840D sl Commissioning Manual page 169

Number Name of Identifier
34010 REFP_CAM_DIR_IS_MINUS
34020 REFP_VELO_SEARCH_CAM
34030 REFP_MAX_CAM_DIST
34040 REFP_VELO_SEARCH_MARKER[n]
34050 REFP_SEARCH_MARKER_REVERSE[n]
34060 REFP_MAX_MARKER_DIST[n]
34070 REFP_VELO_POS
34080 REFP_MOVE_DIST[n]
34090 REFP_MOVE_DIST_CORR[n]
34092 REFP_CAM_SHIFT
34100 REFP_SET_POS[n]
34102 REFP_SYNC_ENCS
34110 REFP_CYCLE_NR
34120 REFP_BERO_LOW_ACTIVE
34200 ENC_REFP_MODE[n]
34210 ENC_REFP_STATE[n]
34220 ENC_ABS_TURNS_MODULO
34300 ENC_REFP_MARKER_DIST[n]
34310 ENC_MARKER_INC[n]
34320 ENC_INVERS[encoder]
34330 REFP_STOP_AT_ABS_MARKER[n]
35150 SPIND_DES_VELO_TOL
36302 ENC_FREQ_LIMIT_LOW
36310 ENC_ZERO_MONITORING
30250 ACT_POS_ABS
Literature
Function Manual Basic Functions; Reference point approach:
IBN CNC: NCK, PLC, drive
Commissioning Manual, 07/2007, 6FC5397-2AP10-3BA0
Name
Reference point approach in minus direction
Reference point approach velocity
Maximum distance to reference cam
Reference point creep speed [encoder
number]
Change of direction on reference cam
[encoder number]
Maximum distance to reference mark;
Maximum distance to 2 reference marks with
distance-coded scales [encoder number]
Reference point positioning velocity
Reference point distance/target point with
distance-coded system [encoder number]
Reference point/absolute offset, distance-
coded [encoder number]
Electronic reference cam shift for incremental
measurement systems with equidistant zero
marks.
Reference point value [reference point
number]
Actual value adjustment to the referencing
measurement system
Axis sequence for channel-specific referencing
Polarity change of BERO
Referencing mode [encoder number]
Status of absolute value encoder [encoder
number]
Absolute value encoder range for rotary
encoders
Reference marker distance with distance-
coded scales [encoder number]
Interval between two reference marks with
distance-coded scales [encoder no.]
Linear measuring system inverse to machine
system [encoder number]
Distancecoded linear measurement system
without destination point [encoder number]
Spindle speed tolerance
Encoder limit frequency resynchronization
Zero mark monitoring
Absolute encoder position at time of
deactivation.
NCK start-up
10.5 Parameterize axis data
Referenc
e
R2
S1
169