Siemens SINUMERIK 840D sl Commissioning Manual page 261

8. Module NCU 720.1 with SINAMICS S120 is inserted into the HW config (see figure
Figure 13-35 HW config with NCU 7x0
As the next step configure a machine control panel with hand wheel.
IBN CNC: NCK, PLC, drive
Commissioning Manual, 07/2007, 6FC5397-2AP10-3BA0
below).
Note
With the <F4> key and confirmation of the question regarding "Reorganize", you can
reorganize the display in the station window.
13.11 PROFIBUS machine control panel on the HMI
Tips
261