Powersys Release Upgrade Check; Powersys Release - Siemens SWT-3000 Equipment Manual

SWT 3000 Equipment Manual

PowerSys release upgrade check

Connect the service PC to the front SUB-D connector X15 from the CSP and start the PowerSys
service program. With the menu <Firmware Download> the service program is connected to the
PowerLink.
Figure 42:

PowerSys release

On the top of the form the FW release is shown. If the release in the device (displayed under "cur-
rent") and the release of the actual service program (displayed under "new") are different <select>
is marked and the download button is activated.
Figure 43:
Verify the PowerSys current and new release and click Download for update of the release. The
Download button is only activated if the current and new release is different.
Continue with commissioning and configuration using PowerSys on the serial port X15 as de-
scribed in detail in the PowerLink manual.
© SIEMENS AG 2008
Starting the firmware download
P3.2.218/101
Display of the PowerSys FW Release
This PowerSys upgrade check must be carried out after each software
upgrade with Memtool, because the PowerSys version is not included
in the "AllInOne" files!
Edition p3_3_2x 08/09
Chapter 3: Service program PowerSys
Rel.: P3.3.2xx/2xx
Page - 31