Table of Contents
Advertisement
LH
WIPER MODULE (Continued)
Fig. 16 TOWER TO TOWER SUPPORT REMOVAL
1 - TOWER TO TOWER SUPPORT
2 - RETAINING BOLTS
Fig. 17 WIPER MODULE RETAINING BOLTS
1 - RETAINING BOLTS
2 - WIPER MOTOR CONNECTOR
Fig. 18 WIPER FRAME GROMMETS
1 - GROMMETS
INSTALLATION
(1) Install the wiper motor onto the wiper module
assembly. Refer to Electrical, Wipers and Washers,
Wiper Motor, Removal.
(2) Install the three retaining bolts to the wiper
motor (Fig. 19).
(3) Install the crank arm and install the one nut to
crank arm (Fig. 19).
NOTE: If replacing module, transfer wiper module
grommets to new module assembly (Fig. 18).
(4) Install the windshield wiper module into vehi-
cle.
(5) Start rear outboard screw first, rear inboard
screw second, and forward outboard screw last.
(6) Start all module mounting screws and bolt by
hand before torquing to specifications.
(7) Connect one wire connector.
(8) Install the three retaining bolts to windshield
wiper module (Fig. 17).
(9) Install the eight bolts to Tower to Tower (cross-
car) support (Fig. 16). Refer to Body for Removal.
(10) Install the wiper module mounting bolt
located on top of the tower to tower beam.
(11) Install the nine screws to cowl screen panel.
Refer to Body for Removal.
(12) Assure wiper module pivots are in "PARK"
position cycling the switch "ON" and "OFF" with
engine off prior to installing arms and blades.
CAUTION: Keep hands clear when cycling the wiper
motor within the wiper module.
(13) Install the driver and passenger side wiper
arms. Refer to Electrical, Wipers and Washers, Wiper
Arm Removal.
(14) Connect the negative battery cable remote ter-
minal to the remote battery post.
WIPER MOTOR
DIAGNOSIS AND TESTING - WIPER MOTOR
Whenever a wiper motor malfunction occurs, dis-
connect motor wire harness and clean the terminals.
Ensure the wire harness is properly connected before
starting diagnosis and repair procedures. Refer to
Wiper Motor Test table.
WIPERS/WASHERS 8R - 21
Advertisement
Chapters
Table of Contents
