Firmware Update - Roland R1000 Series Manual

B0063191 / 1.3
7.11

Firmware update

Roland Systems are continuously further developed. In order to use new functions, firmware
update is required.
For performing a firmware update connect the lower front panel USB slot with the PC.
Then select "Firmware Update" in the configuration mode.
FIRMWARE UPDATE
connect USB(FLASH)
Fig. 92: Display for activating the firmware update
After the USB terminal has been connected to the PC, the following message will appear:
FIRMWARE UPDATE
press UP and ENTER
keys simultaneously
Fig. 93: Messages for activating firmware update
By pressing the keys
FIRMWARE UPDATE
Bootloader active
Fig. 94: Start firmware update
The update will then be executed via the RPP7 software.
For operating the RPP7 software please refer to chapter 10, "Maintenance".
The unit will restart after a successful update.
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Double Sheet Control System R1000 series L20
with integrated fieldbus interface
Note
The firmware update must be performed by qualified personnel only.
On the PC used for firmware update, the actual RPP7 software must be
installed, and the desired firmware version (.bin file) must be available.
The RPP7 software can be found on the supplied CD.
▲
and ENTER simultaneously, the firmware update will be activated.
Attention
By pressing both keys the program memory is deleted.
The firmware update must then be performed without interruption,
in order to keep the system operational.
Manual
Start-up
95