Roland R1000 Series Manual page 29

B0063191 / 1.3
5.2.5.2 DeviceNet (A-coded)
An M12 plug with inverse coding is used for the DeviceNet connection. A T-connector is not
necessary, because the control unit is equipped with input and output.
The corresponding cable plugs are part of the standard scope of supply.
Power consumption via DeviceNet 30mA
M12, 5-pin, A-coded, male connector at control unit
2
3
View:
plug side
5.2.5.3 CanOpen
An M12 plug with inverse coding is used for the CanOpen connection. A T-connector is not
necessary, because the control unit is equipped with input and output.
The corresponding cable plugs are part of the standard scope of supply.
M12, 5-pin, B-coded, male connector at control unit
2
3
View:
plug side
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Double Sheet Control System R1000 series L20
with integrated fieldbus interface
Note
If the L20 is the last participant in the bus, then an external termination
resistor should be placed into the open connector. The resistor is not
included in the scope of supply.
Allocation of DeviceNet connection
Input (Connection X4)
1
5
4
Suppliers / types / notes: Binder, type 715 (A-coded) and others
Note
If the L20 is the last participant in the bus, then an external termination
resistor should be placed into the open connector. The resistor is not
included in the scope of supply.
Allocation of CanOpen connection
Input (Connection X4)
1
5
4
Suppliers / types / notes: Binder, type 715 (B-coded) and others
Manual
M12, 5-pin, A-coded, female connector at control unit
Pin 1 Shield
Pin 2 V +
Pin 3 V -
Pin 4 CAN High
Pin 5 CAN Low
M12, 5-pin, B-coded, female connector at control unit
Pin 1 shield
Pin 2 n. a.
Pin 3 GND
Pin 4 CAN_H
Pin 5 CAN_H
Electrical installation
Output (Connection X3)
1 2
5
4 3
View:
plug side
Output (Connection X3)
1 2
5
3
4
View:
plug side
29