Start-up
7.10
Data backup
For better prevention off loss of data, a data backup procedure is available for the system
configuration and the parameter sets.
The backup is made via the upper USB interface on the front panel. The secured data can then for
example be transferred to an exchange-substituted unit after a unit failure. The data backup is
accomplished with the RPP7 software available from ROLAND ELECTRONIC.
The data backup procedure can be selected in the menu configuration. The following menu is
displayed during the data backup.
Parameter backup
Parameter backup
mode active
Connect upper USB
Fig. 90: Backup of data via USB interface
For backup of data, the upper USB slot on the front panel must be used.
Parameter backup
Parameter backup
mode active
Fig. 91: Display at active connection to PC.
For further information see chapter 10.4.
94
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Double Sheet Control System R1000 series L20
with integrated fieldbus interface
Manual
B0063191 / 1.3