Roland R1000 Series Manual page 89

B0063191 / 1.3
System parameter 14: Adjusting the measuring mode.
system parameter: 14
measuring mode
external continuous
Fig. 78: Adjusting the measuring mode
Possible measurement modes:
• external single:
• demonstration:
• external continuous: The system executes measurements, as long as
external special:
System parameter 15: Specifying the system reaction when 2-sheet is detected.
system parameter: 15
stop if 2-sheet
Fig. 79: Adjusting the 2-sheet reaction
Selectable options:
• no:
• yes:
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Double Sheet Control System R1000 series L20
with integrated fieldbus interface
The system measures once if the "Measurement start" signal is applied.
Each measurement must be initiated separately. The notes in chapter
6.3.2 „timing diagram single measurement" must be observed.
This mode of operation is intended for equipment demonstrations, but
not for normal process operation. The system executes measurements
continuously.
the "Measurement start" signal is applied.
As for "external continuous", but: The highest value reached during a
measurement cycle is displayed and maintained at the outputs until a
new measurement is started.
This also applies for the outputs 0-1-2-Warning.
no
The outputs (0-sheet, 1-sheet and 2-sheet) are activated according to the number of
sheets between the sensors. The equipment does not block operation if double
sheet is encountered.
The outputs (0-sheet, 1-sheet and 2-sheet) are activated according to the number of
sheets between the sensors. If double sheet is detected, the output "2-sheet" is
activated and the equipment is blocked until the 2-sheet condition is cleared.
Manual
Start-up
89