Roland R1000 Series Manual page 32

Electrical installation
5.2.9 Sensor connection (Connections A and B)
The sensor cable SCL20-S-GG is connected at the control unit by plug. All sensors require this
cable type.
.
Fig.10: Cable assignment of SCL20S-GG*
*Until October 2015 cables with a different connection, but with IDENTIC functionality have been delivered.
32
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Double Sheet Control System R1000 series L20
with integrated fieldbus interface
Note
When using the sensor system LAAS40 the connection of the sensor
system with the sensor cables to the terminals A and B is arbitrary. If the
sensor system LAAS40+ is used, then Sensor A (with beam control) must
be mounted above and connected to the control unit at port A.
Connector enclosure isolated (no contact with shield)
Manual
B0063191 / 1.3