General Information Regarding The Configuration; Changing, Setting-Up Or Checking The Configuration - Roland R1000 Series Manual

B0063191 / 1.3
7.5

General information regarding the configuration

The following rules apply to the operation in the configuration mode:
• The configuration mode is activated (while in measurement mode) by pressing the MENU
key.
• The configuration mode is terminated or cancelled by pressing the MENU key.
• The selected / set parameters can be changed when the items are blinking in the display.
• The selected / set parameters are activated by pressing the ENTER key.
7.6

Changing, setting-up or checking the configuration

In order to select, set-up or check the system / program parameters, press the MENU key.
Here either reviewing or changing the configuration can be selected.
Configuration review:
configuration
review
Fig. 34: Indication after calling-up the menu
Configuration change:
configuration
change
Fig. 35: Setting the configuration mode
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Double Sheet Control System R1000 series L20
with integrated fieldbus interface
Note
The correct configuration depends on the communication with the PLC,
on the measurement task and the connected components.
Note The systems info and bus info is displayed by pressing the ENTER key in
the base menu (also see system parameter 27).
Note
In the base menu the LED of the fieldbus coupler is displayed when
▼
pressing the
No changings can be performed.
The measurement mode is not interrupted.
After entering the password it is possible to perform changings.
The following menu option is shown.
Manual
key, see chapter 6.6 "Fieldbus configuration files".
Start-up
73