Table of Contents
Advertisement
.
Configure an E1/T1 card
This chapter contains information about the following topics and the tasks
to configure an E1/T1 card as shown in the following table.
Section
"Configure E1/T1 ports on a Call
Server" (page 84)
Media Gateway 1000E PRI Gateway Installation and Commissioning
Related procedures
•
Procedure 16 "Configuring PRI loops using LD 17"
(page 85)
•
Procedure 17 "Configuring PRI2 loops using LD 17"
(page 86)
•
Procedure 18 "Configuring DPNSS/DASS loops using
LD 17" (page 87)
•
Procedure 19 "Configuring a D-channel interface to
support PRI/NI2 using LD 17" (page 88)
•
Procedure 20 "Configuring a D-channel interface to
support PRI2/EURO D-channels using LD 17" (page 89)
•
Procedure 21 "Configuring DPNSS/DASS D-channels in
the PRI Gateway using LD 17" (page 90)
•
Procedure 22 "Configuring DPNSS/DASS D-channel
interface using LD 74" (page 93)
•
Procedure 23 "Configuring a digital data block using LD
73" (page 94)
•
Procedure 24 "Configuring PRI2 data block for system
timers using LD 73" (page 95)
•
Procedure 25 "Configuring the PRI2 loop timers using
LD 73" (page 96)
•
Procedure 26 "Configuring PRI trunk routes using LD
16" (page 97)
•
Procedure 27 "Configuring PRI2 trunk routes using LD
16" (page 98)
•
Procedure 28 "Configuring DPNSS/DASS trunk routes
using LD 16" (page 99)
•
Procedure 29 "Configuring PRI and PRI2 trunks with
Trunk Data Block data using LD 14" (page 100)
Nortel Communication Server 1000
NN43041-311 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
83
Advertisement
Table of Contents
