Table of Contents
Advertisement
Page 174 of 378
Configure ITG Trunk data on the Meridian 1
Configure the ISL D-channel on the Meridian 1 for the
DCHIP card
Table 31
LD 17 - Configure the ISL D-channel for the ITG DCHIP card (Large Systems) (Part 1 of 3)
Prompt
REQ
TYPE
ADAN
CTYP
GRP
DNUM
PORT
DES
...
USR
553-3001-202
Standard 1.00
Install and configure ITG ISL Trunk node
You must first configure D-channels, route data blocks, and trunks through
the Meridian 1 system TTY. Then, you configure the ESN data blocks to
implement the network dialing plan and translations. Record the D-Channel,
CHIDs, and TNs for the ITG ISL Trunks on the installation summary sheet.
Response
CHG
ADAN
NEW DCH x
MSDL
x
x
x
ITG ISL TRUNK
ISLD
April 2000
Description
Add new data.
Type of data block.
Action Device and Number, where
x = 0-255
Multi - purpose Serial Data Link card type.
Set MSDL switch settings for the ISL DCH port to
RS-422.
Network Group number, where:
x = 0-4
Device Number for I/O ports, where:
x = 0-15
Port number for MSDL card, where:
x = 0-3
16 character designator is "ITG ISL TRUNK"
Specific description if more than one ITG Trunk
route exists.
User.
Dedicated Mode ISDN Signaling Link.
Advertisement
Table of Contents
