Table of Contents
Advertisement
2
Press enter for the password.
3
Enter this command:
cd smaint
4
Enter this command:
ping xxx.xxx.xxx.xxx
Where xxx.xxx.xxx.xxx represents your ELAN MGC IP
address.
5
Observe the result of the ping.
A successful E1/T1 connection results in output as shown in
Figure 23 "Ping results of a successful E1/T1 connection to
ELAN subnet" (page
No connection results in output as shown in
"Verifying a network connection from a PC" (page
Procedure 39
Verifying a network connection from a PC
Step
Action
1
On a PC, click Start and the select Run from the Start Menu.
2
In the Open: box, enter the following and click OK:
ping xxx.xxx.xxx.xxx
Where xxx.xxx.xxx.xxx represents your ELAN MGC IP
address.
3
Observe the result of the ping.
An example of successful results is shown in
results of a successful E1/T1 connection to ELAN subnet" (page
112). An example of no connection is shown in
results of no E1/T1 connection to ELAN subnet" (page
Nortel Communication Server 1000
Media Gateway 1000E PRI Gateway Installation and Commissioning
NN43041-311 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
Initial configuration of the E1/T1 card 111
112).
--End--
--End--
Procedure 39
111).
Figure 23 "Ping
Figure 24 "Ping
112).
Advertisement
Table of Contents
